Filter
Top Products
Disc does not start. The unit
is
not turned on. Turn the power on.
Files are not recognized Use MP3IWMA files encoded properly.
as
an
MP3IWMA file.
Reset
button
Replace with a disc with no scratches.
Write MP3IWMA files onto the disc properly.
Clean the disc with a soft cloth.
1.
Check the speaker connection.
2.
Turn down sound volume. Function can also
be restored by turning the power off and
on
again.
3.
If the sound
is
muted again, consult your store
of purchase.
If the error persists, consult your store of
purchase.
Turn the unit off and check each wire for a
possible short. If the amplifier turn-on lead shorts
out, cover it with insulation such as tape.
Open the front panel
by pressing the
[OPEN] button. Press
the reset button for
about 2 seconds with a
thin rod.
The settings will
remain
in
the ROM
even if you press the
reset button.
Replace with a fuse of the same amperage. If the
fuse blows again, consult your store of purchase.
Consult your store of purchase.
Disc
is
heavily scratched
or warped.
File system
is
not correct. Use
1809660
level 1
,2
or JOLIET or Romeo file
system.
Disc is dirty.
MP3IWMA files are
absent
in
a disc.
There is a disc other than Press the
[~]
button to eject.
a compact disc or foreign
matter already
in
place.
The speaker protection
circuit is operating.
The microprocessor has
malfunctioned due to
noise, etc.
Amplifier turn-on lead is
shorted to ground or
excessive current
is
required.
Incorrect wiring.
The settings
in
the
ROM
failure.
ROM are not
stored properly.
No sound output
when operating the
unit with amplifiers.
Power does not
turn on.
(No sound
is
produced.)
CM05
33