Filter
Top Products
How to operate the tuner
41
VII
Automatically storing stations
into memory. (The automatic
preset mode: ASM)
The automatic preset mode starts.
"ASM ON" will appear on the display,
and stations are automatically entered
in memory under buttons [1] to [6].
These buttons are called the preset
buttons.
ATTENTION
• Pressing the preset buttons ([1] to [6])
allows you to make one-touch station
selections. The frequency of the selected
station is shown on the display.
• When a new station is set in memory, the
station previously set in memory will be
deleted.
• If there are fewer than six receivable
stations, the stations set in the remaining
buttons will be retained.
Manually storing stations into
memory
Store a station to a preset button.
The selected station is stored in the
preset button.
Repeat the above procedure to store
additional stations one at a time in
buttons [1] to [6], and store them in
memory.
Preset station scan
This function enables reception of all the stations
in the preset buttons for five seconds each.
"P SCAN" will appear on the display,
and stations stored under preset
buttons [1] through [6] will be played
for five seconds each.
The main unit will stay tuned to the
desired station.
1
Hold down the [ ] button (for more
than one second) until the beep
sounds.
CAUTION
1
2
If the vehicle's battery is disconnected (for
repairs to the vehicle or for removing the
main unit), all stations in memory will be
lost. In such a case, store stations in the
memory again.
1
Tune to a station frequency you
wish to store by pressing the [<]
or [>] button.
2
Select any button, from [1] to [6],
and press it for more than two
seconds.
CAUTION
1
2
If the vehicle's battery is disconnected (for
repairs to the vehicle or for removing the
main unit), all stations in memory will be
lost. In such a case, store stations in
memory again.
1
Hold down the [ ] button for more
than 1 second.
2
When your desired station is
displayed, press the [ ] button
again.