Filter
Top Products
How to operate the Sound Adjustment Mode
73
XII
Position selector
You can adjust the sound field to the listener seat
position.
This changes to the Position Selector
setting mode.
Pressing each button changes the
position as follows.
If the same button is re-pressed, the
position is reset.
[]:
FRONT
[]:
REAR
[>]:
FRONT-RIGHT
[<]:
FRONT-LEFT
ATTENTION
• FADER or BALANCE cannot be specified
together with Position selector.
• Time Alignment cannot be specified
together with Position selector.
Crossover adjustment (X-Over)
Specified frequency bands are allocated to each
speaker for improved sound integration.
The crossover setting mode is
activated.
Each time the button is pressed, the
channel changes in the following
order.
Front → Rear → Woofer → Front → www
Each time the button is pressed, the
frequency changes in the following
order.
Front/Rear:
63 Hz ↔ 80 Hz ↔ 100 Hz ↔ 125 Hz ↔
160 Hz ↔ 200 Hz ↔ 250 Hz ↔ 315 Hz
↔ 400 Hz ↔ 500 Hz ↔ 630 Hz ↔ 800
Hz ↔ 1 kHz ↔ 1.25 kHz ↔ 1.6 kHz ↔ 2
kHz ↔ 2.5 kHz ↔ 3.15 kHz ↔ 4 kHz ↔
5 kHz ↔ 6.3 kHz ↔ 8 kHz ↔ 10 kHz
Woofer:
20 Hz ↔ 25 Hz ↔ 31.5 Hz ↔ 40 Hz ↔
50 Hz ↔ 63 Hz ↔ 80 Hz ↔ 100 Hz ↔
125 Hz ↔ 160 Hz ↔ 200 Hz
The slope can be set to "Pass", "6 dB/
oct", "12 dB/oct", "18 dB/oct" or "24
dB/oct".
[]:
The slope becomes more gentle.
[ ]:
The slope becomes steeper.
1
Select "Position Selector" by
pressing the [ ] or [ ] button.
2
Press the [ENTER] button.
3
Select the desired position by
pressing the [ ], [ ], [<], or [>]
button.
1
Select "Cross Over" by pressing
the [ ] or [ ] button.
2
Press the [ENTER] button.
3
Press the [ENTER] button to set
the crossover adjustment channel.
4
Select the cut-off frequency by
pressing the [<] or [>] button.
5
Specify the slope by pressing the
[ ] or [ ] button.
6
Repeat the steps 3 to 5 to change
the settings for each channel.