Filter
Top Products
Making changes with Function Mode
83
XIV
The CD-R is read. While it is reading,
"READING" is displayed.
After data reading has completed,
"COMPLETED" is shown for two
seconds on the display, and then
"Eject DATA DISC" appears.
ATTENTION
• To load data into the main unit, you have to
make a special folder. For detail information
about how to make the folder, refer to the E-
iSERV website.
• This function is available only for vehicles
equipped with steering remote with an
interface that operates by detecting voltage.
Manual setup of steering remote
functions (U.S.A. only)
You can manually assign a function to each
steering switch button.
To do so, turn the power supply off and set it
to the standby state. For details, see refer to
"Turning the power on and off" on page 17.
"Customize data?" appears on the
display.
"Long push MODE button" appears on
the display.
The Manual steering remote setting
mode is selected.
ATTENTION
If "FAILED" is shown on the display, press the
[MODE/TAG] button again for more than two
seconds.
9
Press the [ENTER] button.
10
Press the [ (OPEN)] button to
open the front panel, and eject the
CD-R.
CAUTION
1
2
• Do not turn the ignition switch or
power to the main unit ON or OFF (or
remove the front panel of the main
unit) while data reading is in progress.
Data reading will be interrupted and
data may be damaged.
• Only the Volume control can be
operated while the system is reading
data.
1
When the power is off, hold down
the [ /MENU] button for more
than three seconds.
2
Select "STEERING SW" by
pressing the [ ] or [ ] button.
3
Press the [ENTER] button.
4
Select "Manual set" by pressing
the [ ] or [ ] button.
5
Press the [ENTER] button.
6
Hold down the [MODE/TAG] button
for more than two seconds.