Filter
Top Products
How to operate the tuner with an optional XM satellite radio tuner connected (U.S.A./CANADA only)
93
XVII
Category selection
The channel can be selected from among
categories such as ROCK and DANCE.
Consult the XM website for the details of the
categories.
Each time the button is pressed, the
category changes.
[>]:
Advances to the next category.
[<]:
Returns to the previous category.
Direct channel selection
The channel can be selected by inputting the
channel directly.
The mode will change to the direct
channel selection mode.
[>]:
Advances to the next number.
[<]:
Returns to the previous number.
Each time the button is pressed, the
channel number changes in the
following order.
0 ↔ 1 ↔ 2 ↔ 3 ↔ 4 ↔ 5 ↔ 6 ↔ 7 ↔
8 ↔ 9 ↔ 0 ↔ www
Reception starts.
Manually storing channels into
memory
This section covers the storing of channels in the
numbered buttons in memory.
The tuned channel is now memorized
and stored in the button selected.
Repeat the procedure to manually
store the tuned channels into memory,
in turn, for buttons [1] to [6]. These
buttons are called the preset buttons.
ATTENTION
If the vehicle's battery is disconnected (for
repairs to the vehicle or when removing the
main unit), all channels stored in memory will
be lost. In such cases, store the channels in
memory again.
Preset channel scan
This function enables the reception of all the
channels in the preset buttons for five seconds
each.
"P SCAN" will appear on the display,
and channels stored in preset buttons
[1] through [6] will be received for five
seconds each.
The main unit will stay tuned to the
desired channel.
1
Hold down the [<] or [>] button
for less than one second.
1
Press the [MODE/TAG] button for
more than one second.
2
Select the channel number by
pressing the [<] or [>] button.
3
Select channel number to be input
by pressing the [ ] or [ ] button.
4
Press the [ENTER] button.
1
Select the channel to be stored by
pressing the [ ] or [ ] button.
2
Select any button, from [1] to [6],
and press it for more than two
seconds.
1
Hold down the [ ] button for more
than one second.
2
To stop the preset scan mode at
the desired channel, press the [ ]
button again.