Eclipse - Fujitsu Ten CD5030 Car Stereo System User Manual


 
Names of controls and parts
17
III
Turning the power on and off
When the power is turned on, the state used
when the power was turned off such as CD and
tuner playback is restored.
When the vehicle has no ACC position on the
ignition switch, care is needed when turning off
the main unit. Follow Step 2 or Step 3 when
turning off the power.
The power will come ON.
ATTENTION
When the main unit's power is turned on for
the first time or if the battery terminals have
been disconnected because of a reason such
as vehicle maintenance and the power is then
turned back on, the main unit will start up in
FM1 mode. After this, the broadcast stations
will be searched for automatically and stored in
buttons [1] to [6].
The power will go OFF and the main
unit will be in Standby.
Switching Audio Modes
Press the button to switch mode in the
following sequence:
FM/AM SIRIUS
*1
XM
*1
CD(MP3/WMA)
*2
CDC
*1
USB
*4
, or iPod
*4
AUX
*3
BT-Audio
*3
FM/AM www
*1: Cannot be selected if the corresponding
device is not connected to the main unit.
*2: Not displayed if no disc is inserted.
*3: Cannot be selected if the AUX mode or the
BT-Audio mode is not set to ON. For details,
refer to "Switching the AUX mode on and off"
on page 102 or refer to "Switching the
Bluetooth audio mode on and off" on page 36.
*4: Can be selected if the iPod or USB device is
connected and the loaded media type is
determined by the main unit.
Adjusting volume
Turn to the right:
Increases the volume.
Turn to the left:
Decreases the volume.
ATTENTION
Press the [MUTE] button for less than one
second to mute the sound or restore it.
1
Press the [SOURCE/PWR] button
while the power is OFF.
2
Press the [SOURCE/PWR] button
while the power is ON, for more
than one second, until you hear a
beep.
1
Press the [SOURCE/PWR] button
for less than one second.
1
Turn the [VOL] knob right or left.
CAUTION
1
2
Do not adjust the volume or other controls
while driving the vehicle. Do so only while
parked in a safe location.