Filter
Top Products
12
4
BASIC OPERATION
■ Monitor function
This function is used to listen to weak signals or to open the
tone squelch manually.
➥Push and hold [SQL] to monitor the operating frequency.
•“RX” flashes while monitoring.
The [SQL] switch can be set to ‘sticky’ operation in set
mode. (p. 41)
You can monitor duplex communication by pushing the
[SQL] switch when the duplex function is in use. (p. 31)
■ Receive mode selection
Receive modes are determined by the physical properties of
the radio signals. The receiver has 3 receive modes: FM, AM
and WFM modes. TV and ATV (ATV type only) also use WFM
mode. The mode selection is stored independently in each
band and memory channels.
Typically, AM mode is used for the AM broadcast stations
(0.495–1.620 MHz) and air band (118–135.995 MHz), and
WFM is used for FM broadcast stations (76–107.9 MHz).
➥Push [MODE] one or more times to select the desired re-
ceive mode.
S1 3 5 7 9
VOL
FM
146.010.000
TS 15.0
S1 3 5 7 9
VOL
AM
118.000.000
TS 25.0
S1 3 5 7 9
VOL
WFM
76.000.000
TS 50.0
FM AM FM
W
AM mode WFM modeFM mode
S1 3 5 7 9
VOL
RX
FM
146.100.000
TS
15.0
FM
RX