Filter
Top Products
1
1
ACCESSORY ATTACHMENT
◊Antenna
Insert the supplied antenna into the an-
tenna connector and screw down the an-
tenna as shown at right.
Keep the jack cover attached when jack
is not in use to avoid bad contacts from
dust and moisture.
Commercially available antennas (BNC)
may increase receiver performance.
◊
Battery installation
q Remove the battery
cover from the receiver.
w For alkaline battery use,
attach the supplied bat-
tery spacer.
e Install 3 R6 (AA) size al-
kaline batteries or Li-Ion
battery pack (BP-206; p.
46).
•Be sure to observe the cor-
rect polarity.
•Charge Li-Ion battery pack
before use.
Keep battery contacts clean. It’s a good idea to clean bat-
tery terminals once a week.
◊Belt clip
Conveniently attaches to
your belt.
Slide the belt clip into the
plastic loop on the back
of the receiver.
◊Handstrap (not supplied from Icom)
Slide a commercially available handstrap through the loop on
the side of the receiver or belt clip as illustrated below. Facil-
itates carrying.
q
w
e