Filter
Top Products
31
9
DUPLEX OPERATION
Duplex communication uses 2 different frequencies for trans-
mitting and receiving. Generally, duplex is used in communi-
cation through a repeater, some utility communications, etc.
During duplex operation, the transmit station frequency is
shifted from the receive station frequency by the offset fre-
quency. Repeater information (offset frequency and shift di-
rection) can be programmed into memory channels. (p. 14)
This function is not available in the broadcast band (0.495
–1.620 MHz) except for U.S.A. and Canada versions.
q Set the receive station frequency (repeater output fre-
quency).
w Set the shift direction and offset of the transmit station fre-
quency as described below.
e Push and hold [SQL] to monitor the transmit station fre-
quency (repeater input frequency) directly.
◊Duplex shift direction
q Push [FUNC] + [(MODE)SET] momentarily to enter set
mode.
•Select a non-band scope screen in advance for color LCD.
w Rotate [DIAL] until “Duplex” or “dUP” appears.
•“dUP” disappears after 1 sec. and “dP” appears when color LCD
is OFF.
e Push [↔] or rotate the tuning dial while pushing [FUNC] to
select “–DUP” or “(+)DUP.”
•“–DUP” or “(+)DUP” indicates the transmit station frequency for
minus shift or plus shift, respectively.
r Push [(MODE)SET] to exit set mode.
Duplex direction set
mode
Tone Squelch: OFF
Tone Freq. : 88.5
Duplex : OFF
Offset Freq.: 0.600
Scan Resume : 2SEC
Tone Squelch: OFF
Tone Freq. : 88.5
Duplex : -DUP
Offset Freq.: 0.600
Scan Resume : 2SEC
Tone Squelch: OFF
Tone Freq. : 88.5
Duplex : +DUP
Offset Freq.: 0.600
Scan Resume : 2SEC
Minus shift
Plus shift
FM
P
S1 3 5 7 9
VOL
FM
146.100.000
TS 15.0
DUP
–DUP