Filter
Top Products
19
6
SCAN OPERATION
■ Full/band/programmed scan
Scanning searches for signals automatically and makes it
easier to locate new stations for listening purposes, etc.
q Select VFO mode with [V/M].
w Make sure the squelch is set to the threshold point.
•Select automatic squelch (AUTO) or a level (1–9) where the
noise is just muted. (p. 10)
e Push and hold [↔], then rotate [DIAL] to select desired
scan edge.
•“ALL” for full scan, “BAND” for band scan or “PROG(RAM) 0”–
“PROG(RAM)24” for programmed scan. (see the next page)
r Release [↔] to start the scan.
•Decimal point(s) flashes while scanning.
•“PSKIP” appears when the frequency skip function is turned ON.
(p. 19)
•“0P”–“24P” flash to indicate which pair of scan edges is being
scanned.
•To change the scanning direction, rotate [DIAL].
•If the pocket beep function is activated, the receiver automati-
cally selects the tone squelch function when a scan starts.
t To stop the scan, push [↔] again.
If the same frequencies are programmed into a pair of
scan edges, programmed scan does not start.
For programmed scan, scan edges must be programmed
in advance. Program scan edges in the same manner of
programming a memory channel (p. 14) and select a scan
edge. (p. 21)
A tone scan function is available to search for subaudible
tones (e.g. when you want to find a subaudible tone fre-
quency necessary to open a repeater or to open the tone
squelch). See p. 30 for details.
S1 3 5 7 9
VOL
FM PSKIP
146.100.000
TS 15.0
PROGRAM 0
S1 3 5 7 9
VOL
FM PSKIP
146.100.000
TS 15.0
BAND
S1 3 5 7 9
VOL
FM PSKIP
146.100.000
TS 15.0
ALL
Band scanProgrammed scan 0 Full scan