Filter
Top Products
24
6
SCAN OPERATION
■ Frequency skip function
◊Programming a skip frequency
Unwanted frequencies can be skipped and programmed as
skip channels when full scan, band scan or programmed scan
is pausing.
q Start full scan, band scan or programmed scan. (p. 19)
w While receiving an unwanted signal and scan pauses,
push [FUNC] + [(V/M)SKIP] for 2 sec. to program the re-
ceived frequency as a skip frequency.
•The receiver emits 3 beeps and the scan resumes.
•Non-programmed memory channels (blank channels) are used
for skip frequency programming in reverse sequence.
•To scan the skip frequency after programming, cancel the skip
information (p. 22) or clear the memory channel (p. 16).
◊Frequency skip function ON/OFF
The frequency skip function can be turned OFF. In this case,
the frequencies will not be skipped even if skip information is
programmed and “PSKIP” or “P” does not appear.
q Select VFO mode with [V/M].
w Push [FUNC] + [(V/M)SKIP] to toggle the frequency skip
function ON or OFF.
•“PSKIP” or “P” appears when the function is turned ON.
FM FM
P
S1 3 5 7 9
VOL
FM
146.010.000
TS 15.0
S1 3 5 7 9
VOL
FM PSKIP
146.010.000
TS 15.0
The frequency skip
function is OFF.
The frequency skip
function is ON.
FM
P
RX
FM
P
RX
S1 3 5 7 9
VOL
RX
FM PSKIP
370.475.000
2P
TS 15.0
S1 3 5 7 9
VOL
RX
FM PSKIP
370.475.000
H49
TS 15.0
Indication while programmingIndication while pausing