Filter
Top Products
45
Setting the Speaker Type
Using this function to set the diameter of the
speaker optimizes the sound quality to the
speaker diameter.
Each time you touch [ SP ] to select the speaker
type as follows:
" STANDARD "
Speaker with a general diameter
" NARROW "
Speaker with small diameter
" WIDE "
Woofer with a large diameter
" MIDDLE "
Woofer with a small diameter
This function fine-tunes the settings for bass
center frequency, bass level, bass quality factor,
bass extension, treble center frequency, and
treble level which are recalled by Sound preset
under Audio control.
Storing Your Sound Settings
Hold down a [ 1 ] - [ 5 ] for two seconds or more
except during the bass center frequency, bass
level, bass quality factor, bass extension, treble
center frequency, and treble level adjust mode.
Recalling your sound settings
Touch [ 1 ] - [ 5 ] except during the bass center
frequency, bass level, bass quality factor, bass
extension, treble center frequency, and treble
level adjust mode.
Ending the Sound Preset Screen
Touch [ RTN ] to return to the audio control
screen.
NOTE
Ending the Audio Control Screen
Touch [ RTN ] to return to the sound effect menu
screen.
Switching to the Sound Preset Screen
Touch [ PRO ] to switch to the Sound preset
screen.
No display [ PRO ] when the KDS-P900/P901 is
connected.
Recalling the Kenwood Preset Sound
Each time you touch [ ] or [ ], the preset sound
setting switches between the “Flat“, “Easy“,
“Jazz“, “Pops(Top40)“ and “Rock“.
Adjusting the Center Frequency of the
Bass
Each time you touch [ ] or [ ] to switch the
center frequency of the bass as follows:
60 / 70 / 80 / 100 Hz (Only when the bass quality
factor is set to 1.00, 1.25 or 1.50) / 150 Hz (Only
when the bass quality factor is set to 2.00)
Adjusting the Bass Quality Factor
Each time you touch [ ] or [ ] to switch the
Bass quality factor as follows:
1.00 / 1.25 / 1.50 / 2.00
Adjusting the Center Frequency of the
Treble
Each time you touch [ ] or [ ]to switch the
center frequency of the treble as follows
10.0 / 12.5 / 15.0 / 17.5 kHz
Switching the Bass Extend mode On/Off
Each time you touch [ DC ] to switch the function
on and off.
When the function is on, the [ DC ] icon to indicate
to amber and low frequency response is extended
by 20%.
NOTE
Q
L
O
K
E
M
N
P
R
J