Filter
Top Products
50
5.1 Channels Surround Processor Control Function
H
F
A
B
D
C
E
G
Adjust the slope
Each time you touch [ ] or [ ] to adjust the
slope (12dB, 18dB and 24dB).
Setting the phase for Sub Woofer
output
Each time you touch [ Sub Phase ] to switch the
phase as follows:
" NORMAL "
0°
" REVERSE "
180°
Storing Your Settings of the Crossover
network/Delay time
Touch [ 1 ] -[ 6 ] for at least two seconds.
Recalling your settings of the Crossover
network/delay time
Touch [ 1 ] -[ 6 ] for the desired crossover network
and delay time setting.
Switching to the Delay Time Setting
Screen
Touch [ DTA ] to switch to the delay time setting
screen.(see p.51)
Returning to the Sound Effect Menu
Screen
Touch [ RTN ] to return to the sound effect menu
screen.
Adjusting the High-pass filter for Rear
output
Adjust the frequency
Each time you touch [ ] or [ ] to adjust the
frequency as follows:
THR (through) / 30Hz / 60Hz / 90Hz / 120Hz /
150Hz / 180Hz / 250Hz
Adjust the slope
Each time you touch [ ] or [ ] to adjust slope
(12dB, 18dB and 24dB).
Adjusting the High-pass filter for Front
output
Adjust the frequency
Each time you touch [ ] or [ ] to Adjust the
frequency as follows:
THR (through) / 30Hz / 60Hz / 90Hz / 120Hz /
150Hz / 180Hz / 250Hz
Adjust the slope
Each time you touch [ ] or [ ] to adjust the
slope (12dB, 18dB and 24dB).
Adjust the frequency of the Low-pass
filter for Sub Woofer output.
Adjust the frequency of the Low-pass filter
Each time you touch [ ] or [ ] to adjust the
frequency as follows:
30Hz / 60Hz / 90Hz / 120Hz / 150Hz/ 180Hz /
250Hz
Adjust the slope
Each time you touch [ ] or [ ] to adjust the
slope (12dB, 18dB and 24dB).
Adjusting the High-pass filter for Center
output
Adjust the frequency
Each time you touch [ ] or [ ] to adjust the
frequency as follows:
THR (through) / 30Hz / 60Hz / 90Hz / 120Hz /
150Hz / 180Hz / 250Hz
A
D
B
F
C
H
G
Crossover Network Setting Screen
E
ABDE
You cannot operate when the “Sub Woofer“ is set
to “OFF“( see P.47 ).
A
You cannot operate when the “Multi channel“ is
set to “3/0“ or “2/0“ on the digital effect setting
screen ( see P 47 ) <When playing with multi-
channels>.
E
•You cannot operate when the “Center SP“ is set
to "OFF" ( see P 47 ) <When playing with the 2ch
PCM signal>.
•You cannot operate when the “Multi channel“ is
set to “2/2“ or “2/0“ ( see P 47 ) <When playing
with multi-channels>.
NOTE
NOTE
NOTE