Filter
Top Products
64
Installation
Installing the Antenna Units
• Attach the antenna to the inner glass surface of the rear window using double-sided tape. Carefully check the installation
location as the tape can only be stuck on once.
• If the surface temperature of the glass of the rear window is low, warm it by turning on the power of the rear defogger.
A cold window glass surface will weaken the adhesive strength of the double-sided tape.
Also, if installation inside the cabin is performed on a day with high humidity or when it is raining, the high humidity level will
weaken the adhesive strength of the double-sided tape.
• Do not install the antenna in a location where it may obstruct the field of view during driving, such as on the windshield.
Check the location where the antenna is to be attached.Clean
off any grease or dirt from the installation location using the
supplied glass cleaner
(Accessory Q), clean the area with water
and allow to dry.
Clean the glass thoroughly as failure to clean the glass can not
only weaken the adhesive strength of the double-sided tape,
but may also cause it to come loose.
Remove the protective strips from the antenna parts and the
back of the antenna unit.
Attach the double-sided tape of the antenna parts and the
antenna unit to the rear windshield glass. Attach the double-
sided tape by firmly pressing down from the top. Secure cables
using the supplied clampers.
After attaching the antenna with the double-sided tape, allow it
to sit undisturbed for 24 hours. Take care not to apply force to
the antenna or allow it to get wet during this time.
Connect the antenna cable to receiver unit.
5
4
3
2
2 CAUTION
1
Rear seat
Rear window
Bundle cables with the
clamper bar
(Accessory R)
Antenna parts
Antenna unit