Filter
Top Products
8 SPAN-CPT User Manual Rev 8
Notices
The following notices apply to the SPAN-CPT.
FCC Notices
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
SPAN-CPT complies with the radiated and conducted emission limits for a Class B digital device. The
Class B limits are designed to provide reasonable protection against harmful interference in a residential
installation.
The equipment listed generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
• Re-orient or relocate the receiving antenna
• Increase the separation between the equipment and the receiver
• Connect the equipment to an outlet on a circuit different from that to which the receiver is
connected
• Consult the dealer or an experienced radio/TV technician for help
Industry Canada
SPAN-CPT Class B digital apparatuses comply with Canadian ICES-003.
SPAN-CPT appareils numérique de la classe B sont conforme à la norme NMB-003 du Canada.
CE Notice
The enclosures carry the CE mark.
"SPAN-CPT is in compliance with the essential requirements and other relevant provisions of Directive
1999/5/EC."
In order to maintain compliance with the limits of a Class B digital device, it is required to
use properly shielded interface cables (such as Belden #9539 or equivalent) when using
the serial data ports, and double-shielded cables (such as Belden #9945 or equivalent)
when using the I/O strobe port.
Changes or modifications to this equipment, not expressly approved by NovAtel Inc., could
result in violation of FCC, Industry Canada and CE Marking rules and void the user’s
authority to operate this equipment.