Filter
Top Products
16
Installation
Configure the network with the projector
This example explains how to set the following configuration.
IP Address : 192.168.1.201
Subnet Mask : 255.255.255.0
Default Gateway : 192.168.1.1
DNS : 0.0.0.0
A
1 Selection of network menu [Network]
Turn on the projector and display the menu on the screen. Select the Network icon
from the Setting sub menu using the pointers, and then press the SELECT button
on the remote control or on the projector. Confirm that its mode is set On. If not,
change mode to On using the pointer 7/8.
2 Configuration for IP Address/ Subnet mask/Default Gateway*/DNS*
Press the SELECT button again, the fol-
lowing network setting menu appears on
the screen. Enter the specified network
address. The following is an example of a
network configuration.
* In the network environments not using a Gateway or Router, the Default Gateway address
should be set to [0.0.0.0]. If you do not use the functions E-mail or DNS server, it is also set
[0.0.0.0] for the DNS address.
* The above on-screen display may differ from
the actual display depending on the functions
of the projector you use.
NETWORK SETTING
IP Address
Sub net
Gateway
DNS
192 168 1 201
192 168 1 1
255 255 255 0
0000
SET
CANCEL