Filter
Top Products
64
Use of Serial Port
Control the projector with Telnet
This product allows you to control the projector by using the Telnet application.
Normally, it is used to control the external equipment connected to the serial port and
also control the projector itself by specifying the telnet port no.10000.
Specify port no. 10000 as the right on the
serial port setting page. This function
does not depend on other setting items.
In the setting of the computer, specify
the port no. 10000 at the procedure 3 on
the previous setting example page as the
below.
Host name : 192.168.0.2
(type a projector IP address)
Port : 10000
Terminal type : vt100
After established the communication, type the
password and the command for controlling the
projector and then enter the “Enter” key.
The right table shows the typical command lists
for controlling our projectors and please consult
your local dealer for further information of anoth-
er commands.
Command Function
C00 Turns the projector on
C01 Turns the projector off
C05 Selects Computer 1
C06 Selects Computer 2
C07 Selects Video
C09 Volume up
C0A Volume down
C0B Mute on
C0C Mute off
C0D Video mute on
C0E Video mute off
C1C Menu display on
C1D menu display off
Command list table