Sanyo POA-PN10 Car Stereo System User Manual


 
41
Network Unit
OWNER’S MANUAL
ENGLISH
Control the projector
Image Adjustment
This function is to adjust the projected picture image and set the image
mode. For selection of image mode, select desired image mode among the
"Standard", “Real”, "Cinema", "Image1", "Image2", Image3" and "Image4"
with the "Image Adjustment Mode"
pull down button and then press
the Set button. The setting items
are switched automatically accord-
ing to selected input mode, com-
puter or video input. To adjust the
controls, press the + or - buttons to
increase or decrease the value, or
enter the value directly onto the
text area of the control and then
press Set button. The adjustment
items and operation are listed
below. The value next to each con-
trol represent the current control
value and status.
The mode "Image1" to "Image4" can
be stored as your preferred image
mode through "Save Adjustment"
item located on lower part of the
page. Select an image number from
the pull down menu button and then
press the Save button. To cancel your
change, press the Return button.
The "Original Mode" is to indicate which
image mode are applied to the user preset
modes "Image1" to "Image4".
Adjustment items Operation
Image adjustment mode Select image mode among the Standard, Real **, Cinema*, Image1
to Image4 with pull down button menu . Image1 to 4 are user preset
mode.
Adjustment items Contrast, Brightness, Sharpness*, Gamma, White Balance, Color Temperature,
Tint*, Color*, Noise Reduction*, Progressive*
* Controls for video input, ** Controls for computer input
Comment Type the comment in the text area and press the Save button.
Range of control value is as follows: Sharpness: 0 to 31, Gamma: 0 to 15, others: 0 to 63
Current set
value
* The displayed adjustment items may dif-
fer from the actual depending on the func-
tions of projector you use.