Filter
Top Products
33
Network Unit
OWNER’S MANUAL
E-Mail setting
ENGLISH
4 Condition selection for sending alert message
Check the condition items
under which alert messages
will be sent and press the Set
button.
Please refer to chapter
“Examples :Type and con-
tents of alert messages”
described on next page.
Note:
A free message can be sent when the lamp use time reaches the preselected
lamp use time.
Check the “lamp use time” and enter a setting time. Input a free message on the
attached message text box and then press the Set button.
The length of message should be less than 256 characters.
Examples: Type and contents of alert mail
When the projector has an abnormality, the following alert messages are sent to the
registered E-mail address according to your selected condition. Administrator or user
can take an efficient action quickly by receiving this massage. This is very useful to
maintain and service the projector.
The following are examples of received messages.
● When the internal temperature is too high:
✐ The Network Unit let users know the information which thermal sensor [A], [B] or [C]
inside the projector detected the abnormal temperature risen and so the projector
was turned off. Please refer to page 37 for the location of the sensors [A], [B] and
[C], and temperature. Also see the owner's manual of the projector for further
details.
TITLE: Message from projector
01-01-2003 00:59
Projector Model Name: XT10A/XT15A
TCP/IP: 192.168.0.2 Projector Name: myProjector
It sends you following massage.
*The Projector lamp is turned off, because internal projector temperature is too
high.
Wait Temperature Warning Indicator turned off,turn the Projector on again.
If the Indicator continues to flash,check the air filter for dust accumulation.
[A] 36.5 Degree [B] 46.5 Degree [C] 58.2 Degree
Temperature of Sensor C is too high.