Filter
Top Products
54
Controlling the Multi-Projectors
Load and apply the setting value
The control sets saved for each projector (p. 48) can be used while the multi-con-
trolled projectors function is being used. Select a setting number from the item Load
Setting No. with the pull down menu button and then press the Set button. The con-
trol values stored with selected set number for each projector will be applied to the
individual projector assigned to that set. The control values will not be applied to all of
the projectors under multi-control.
Control multi-projectors at the same time
The valid controls are shown below. Please refer to chapter "Control the Projector" on
page 35 for further control and description. When the control button or setting button
is pressed, the registered projectors for the multi-control are controlled at the same
time.
* These control items differ from each selected input mode and functions of the projector
you use.