Filter
Top Products
When you select EXIT or if you press the MENU button after making changes, a
pop-up menu displays available Save options (see “…About saving changes”).
For more information about the Password, see “…About the Password”.
…$ERXWHQWHULQJQXPEHUVXVLQJIURQWSDQHOEXWWRQV
Alt Mode interface: The Alt Mode interface cannot be used for direct numeric en-
try. Some Alt Mode options let you enter values directly using front panel buttons.
To operate the front panel for setting numeric functions while in Alt Mode, per-
form the following actions.
Each change made must be saved before exiting (see “…About saving changes”).
Pressing the or arrow button displays available options (numbers) in fixed
steps. Note that stepping speed increases if you press and hold down the arrow
button.
If the selected value is out of range or conflicts with another setting, a pop-up mes-
sage displays information about the error, or substituted (default) value. For a list
of frequency-related error messages, see Table 6.
Menu interface: Some menu options let you enter values directly using front panel
buttons. To enter numbers directly and to operate numeric functions, perform the
following actions.
Changes made must be saved before exiting (see “…About saving changes”). If
you press SELECT to clear the entry, pressing the or arrow button displays
available options (numbers) in fixed steps.
Repeat this action to change the current setting. If a value entered is out of range or
conflicts with another setting, a pop-up message displays information about the
error, or substituted (default) value. For a list of frequency-related error messages,
see Table 6.
…$ERXWVDYLQJFKDQJHV
Alt Mode interface: After making changes to the current setup via any Alt Mode
function, you must save or discard the changes. Saved changes are used to update
the current receiver settings which are stored in non-volatile memory. Discarding
changes restores the previously saved settings. You can also cancel the operation to
make further changes. For more information about Alt Modes, see “Alt Mode op-
eration”.
When you press the ALT, VIEW or STANDBY button after making changes, “sav?”
is displayed at the front panel (see Figure 4).