Filter
Top Products
6HDUFK6HWXSPHQX
Automated signal search options are available from the Search Setup menu for
setting up your Headend Satellite Receiver (see also “Receiver Setup menu”).
Available options: Move to Exit and press SELECT (or press 1 and then SELECT)
to return to the previous menu.
You can view or change the current setup. Your dealer/reseller or local service
provider can advise you about what receiver settings you may need to change. The
following Search setup information is displayed on-screen.
…
$ERXWWKH6HDUFKRSWLRQ
Searching for a signal with the “Search” option is used for restoring normal re-
ceiver operation if the received signal is interrupted or lost, or is changed by the
local broadcast satellite services provider.
A signal search is enabled by setting the Search option to ON at the Search Setup
menu, and is activated automatically only if the carrier signal is interrupted or lost
for more than 20 seconds (with menus not displayed). If the lost carrier signal is
recovered within 20 seconds, the receiver will attempt to synchronize with the last
locked channel. If unavailable, the “NO CHANNEL” banner is displayed. If the
lost carrier signal is not recovered within this time, a signal search is activated
automatically.
Once activated, the receiver begins searching for a signal associated with the cur-
rent Network ID. When a possible match is found, the search is temporarily inter-
rupted while the receiver attempts to synchronize with the found signal. If syn-
chronization is successful, the signal status is displayed on-screen. Settings can be
saved, as required while in the Search Setup menu before exiting to video (current
channel). If receiver synchronization cannot take place, the signal is discarded and
the signal search is automatically resumed.
If no signal is found, the signal search continues indefinitely, and must be manu-
ally terminated. A signal search can also be manually terminated, or interrupted
and resumed with different settings. To disable the search, set the Search to OFF. A
search is also terminated automatically if the current channel is changed, or if the
MENU button is pressed (see also “…About the Find option” and “…About the
Signal State”).