Filter
Top Products
Pop-up error messages that display for invalid settings are listed in Table 6. Use
this information to help you correct frequency-related receiver setup errors. The
pages that follow contain detailed setup information for each Receiver Setup menu
option.
Available options: Press 1 to save the new settings (Yes), or press 2 to discard all
changes (No), or press 3 to cancel the operation (Cancel).
Repeat this action to change to another Frequency Mode. A valid Frequency Mode
is always required (i.e., for setting the L-Band or Downlink frequency).
Available options: Press 1 to save the new settings (Yes), or press 2 to discard all
changes (No), or press 3 to cancel the operation (Cancel).
Repeat this action to change to another frequency. A valid operating Frequency is
always required (i.e., for setting the L-Band or Downlink frequency).
Available options: Press 1 to save the new settings (Yes), or press 2 to discard all
changes (No), or press 3 to cancel the operation (Cancel).
Repeat this action to change to another frequency. A Local Oscillator #1 frequency
setting is required only if Downlink or L-Band/1 Frequency Mode are set (N/A
1
displayed if Frequency Mode set to L-Band/2).
1
Not Applicable