Filter
Top Products
Available options: Press 1 to save the new settings (Yes), or press 2 to discard all
changes (No), or press 3 to cancel the operation (Cancel).
Repeat this action to change to another Symbol Rate. The selected Symbol Rate
must match the Symbol Rate associated with the transmitted signal. If you are un-
sure about which Symbol Rate to use, contact your dealer/reseller, or local service
provider.
Available options: Press 1 to save the new settings (Yes), or press 2 to discard all
changes (No), or press 3 to cancel the operation (Cancel).
Repeat this action to change the Network ID (see also “…About the Network ID”).
Changing the Network ID is normally required only when authorized subscriber
services are changed, or when new or different subscriber services are made avail-
able (see Figure 12). If you are unsure about which Network ID to use, contact your
dealer/reseller, or local service provider. Changing the Network ID may also re-
quire that you execute a signal search (see “Search Setup menu” and “…About the
Find option”).
«
$ERXWWKH6LJQDO6WDWH
During normal operation, your receiver is synchronized with the received LNB
signal (confirmed by the “Lock, Sig“ status display). If the receiver is able to syn-
chronize to a carrier frequency only and no MPEG stream is present or is recog-
nized, the “Lock, No Sig“ status is displayed, and the Signal indicator LED is OFF. If
no digital carrier signal is detected, the “No Lock“ status is displayed, and the Sig-
nal indicator LED is also OFF. If a signal search activated using the “Find” option
is in progress, the “Searching“ status is displayed. If a signal search activated using
the Search function is in progress, the message “Searching for a signal“ is displayed.
For more information about the Find option, see “…About the Find option”. For
more information about signal searches, see “…About the Search option”.
«
$ERXWWKH)LQGRSWLRQ
Searching for a signal with the “Find” option can be used if you are installing your
Headend Satellite Receiver for the first time, or if you are modifying the current
receiver setup. Activating the Find function forces the receiver to search for a sig-
nal immediately. Signal searches are also performed automatically to restore nor-
mal receiver operation if the received signal is interrupted or lost, or is changed by
the local broadcast satellite services provider.