Filter
Top Products
Available options: Press 1 to save the new settings (Yes), or press 2 to discard all
changes (No), or press 3 to cancel the operation (Cancel).
Repeat this action to change to another frequency. A Local Oscillator #2 frequency
setting is required only if the Downlink or L-Band/2 Frequency Mode is set (N/A
1
displayed if Frequency Mode set to L-Band/1, or if operating Frequency in C-Band
range [3.7-4.2 GHz]). The Local Oscillator #2 frequency used must be greater than
the Local Oscillator #1 frequency.
Available options: Press 1 to save the new settings (Yes), or press 2 to discard all
changes (No), or press 3 to cancel the operation (Cancel).
Repeat this action to change to another frequency. A Crossover frequency setting is
required only if the Downlink Frequency Mode is set (N/A
1
displayed if Fre-
quency Mode set to L-Band/1 or L-Band/2 [not dual Ku-Band LNB operation]).
The Crossover frequency setting determines which LNB is used (only for dual-LNB
operation).
Available options: Press 1 to save the new settings (Yes), or press 2 to discard all
changes (No), or press 3 to cancel the operation (Cancel).
Repeat this action to change the polarization. When a Horizontal polarization is
set, a 19 volt DC signal is output via the receiver rear panel SATELLITE connector.
When a Vertical polarization is set, a 13 volt DC signal is output via this connector.
Observe the effect of the polarization change by checking the displayed relative
Signal Strength and Signal Quality values (see Figure 12). Higher numbers are
better. If you are unsure about which polarization to use, contact your
dealer/reseller, or local service provider.
Available options: Press 1 to save the new settings (Yes), or press 2 to discard all
changes (No), or press 3 to cancel the operation (Cancel).
Repeat this action to change the FEC Rate. The selected FEC Rate must match the
FEC Rate associated with the transmitted signal. If you are unsure about which
FEC rate to use, contact your dealer/reseller, or local service provider.