Filter
Top Products
Available options: Press 1 to save the new setting (donE), or press 2 to discard all
changes (rstr), or press 3 to cancel the operation (abrt).
Repeat this action to display or change the operating frequency. You can use the
/ arrow buttons to change between low and high resolution. Note that when
displaying high resolution (i.e., least significant digits), the decimal point flashes
ON and OFF repeatedly (see “…About frequency settings”). The operating fre-
quency can be displayed from any channel, but can only be changed from the In-
staller Channel (see “…About the current channel”).
)UHTXHQF\0RGH
The Frequency Mode option is an Alt-1 Mode function. The mode selected is the
Downlink (dnLn) or L Band (Lb1 or Lb2) Frequency Mode used by the receiver. If
you are unsure about which Frequency Mode to use, contact your dealer/reseller,
or local service provider.
Perform the first step if you are changing the Frequency Mode.
Available options: Press 1 to save the new setting (donE), or press 2 to discard all
changes (rstr), or press 3 to cancel the operation (abrt).
Repeat this action to change the Frequency Mode. The Frequency Mode can be
displayed from any channel, but can only be changed from the Installer Channel
(see “…About the current channel”). Each Frequency Mode corresponds to a valid
Local Oscillator or Downlink frequency (see also “LO Frequency #1”, “LO Fre-
quency #2”) and “Crossover frequency”).
/RFN/HYHO
The Lock Level option is an Alt-2 Mode function. The Lock Level determines what
receiver/interface options are available for viewing and/or modification. If you
are unsure about which Lock Level to use, contact your dealer/reseller, or local
service provider.
Perform the first step if you are changing the Lock Level.