Filter
Top Products
Repeat this action to change the FEC Rate. The selected FEC Rate must match the
FEC Rate associated with the transmitted signal. If you are unsure about which
FEC rate to use, contact your dealer/reseller, or local service provider.
Available options: Press 1 to save the new settings (Yes), or press 2 to discard all
changes (No), or press 3 to cancel the operation (Cancel).
Repeat this action to change to another Symbol Rate. The selected Symbol Rate
must match the Symbol Rate associated with the transmitted signal. If you are un-
sure about which Symbol Rate to use, contact your dealer/reseller, or local service
provider.
Available options: Press 1 to save the new settings (Yes), or press 2 to discard all
changes (No), or press 3 to cancel the operation (Cancel).
Repeat this action to change the Network ID (see also “…About the Network ID”).
Changing the Network ID is normally required only when authorized subscriber
services are changed, or when new or different subscriber services are made avail-
able (see Figure 12). If you are unsure about which Network ID to use, contact your
dealer/reseller, or local service provider. Changing the Network ID may also re-
quire that you execute a signal search (see “Search Setup menu” and “…About the
Find option”).
NIT (Network Information Table) contains lists of channels and frequency plans
used on the network. The NIT is transmitted from the uplink. In most cases, the
NIT is needed and, therefore, the YES option should be selected. To find out
whether or not you should use the NIT on your receiver, contact your service pro-
vider.
Available options: Press 1 to save the new settings (Yes), or press 2 to discard all
changes (No), or press 3 to cancel the operation (Cancel).