Filter
Top Products
%DXG5DWH
The Baud Rate option is an Alt-2 Mode function. The selected Baud Rate sets the
Baud Rate for the serial Expansion Port (if used). If you are unsure about which
Baud Rate to use, contact your dealer/reseller, or local service provider.
Available options: Press 1 to save the new setting (donE), or press 2 to discard all
changes (rstr), or press 3 to cancel the operation (abrt).
Repeat this action to change to another Baud Rate. The Baud Rate can be displayed
or changed from any channel.
)(&5DWH
The FEC Rate option is an Alt-1 Mode function. The selected FEC Rate must match
the FEC Rate associated with the transmitted signal. If you are unsure about which
FEC rate to use, contact your dealer/reseller, or local service provider.
Perform the first step if you are changing the FEC Rate.
Available options: Press 1 to save the new setting (donE), or press 2 to discard all
changes (rstr), or press 3 to cancel the operation (abrt).
Repeat this action to change the FEC Rate. The FEC Rate can be displayed from any
channel, but can only be changed from the Installer Channel (see “…About the
current channel”).
%DQG6HOHFW
Display only: The Band Select display option is an Alt-1 Mode function. The oper-
ating (frequency) band displayed identifies the operating L-Band frequency
(C-Band or Ku-Band) used by the receiver (see also “Frequency Mode”). The oper-
ating band can only be set via the menu interface. If you are unsure about which
frequency to use, contact your dealer/reseller, or local service provider.
The operating Band can be displayed from any channel.