Filter
Top Products
Installing the Equipment
Page 2-6 Reference Guide: TT128x High Definition Professional Receiver/Decoder
ST.RE.E10141.5
Protection from Moisture
Do not install this equipment in areas of high humidity or where there is a
danger of water ingress.
2.3.3 Installing Cables - Safety
Power supply cables should be routed so that they are not likely to be
walked on or pinched by items placed upon or against them. Pay particular
attention to cables at plugs, convenience receptacles, and the point where
they exit from the appliance.
Do not run ac power cables in the same duct as signal leads. Do not move
or install equipment whilst it is still attached to the mains supply. Ensure
safety and ESD precautions are observed whilst inter-connecting
equipment.
2.4 EMC Compliance Statements
1
2.4.1 EN 55022/AS/NZS 3548
This is a Class A product. In a domestic environment this product may
cause radio interference in which case the user may be required to take
adequate measures.
2.4.2 FCC
This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment.
This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instruction manual,
may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in
which case the user will be required to correct the interference at his own
expense.
2.5 AC Supply Operating Voltage and Fusing -
Safety Information
2.5.1 AC Power Supply
The IRD operates from an wide-ranging mains power supply (100-120 Vac
or 220-240 Vac 50/60 Hz nominal) and is designed for use in ambient air
temperature in the range 0°C to +50°C. There are no links etc. to be
altered for operation from different supply voltages. The full Technical
Specification is given in Annex B, Technical Specification.
1
The EMC information was correct at the time of manufacture. The EMC tests were performed with the Technical Earth
attached.