TANDBERG TT1282 Car Satellite TV System User Manual


 
Operating the Equipment Remotely
Reference Guide: TT128x High Definition Professional Receiver/Decoder Page 4-3
ST.RE.E10141.5
4.1 Remote Control
4.1.1 Introduction
The IRD can be remotely controlled in a variety of ways. The basic control
methods are:
TANDBERG Device Controller (TDC)
Third-party application using TANDBERG SNMP MIB protocol
Third-party application using Alteia remote control protocol
(RS-232/RS-485)
TANDBERG Director (over-air)
Common for all control methods is that the IRD needs to be set up to
accept the remote control handling. Once in remote control mode, it
cannot be locally controlled unless the remote control is deactivated.
4.1.2 Remote Protocol Control Documentation
For information about remote control protocols contact TANDBERG
Television.
4.1.3 Configuring the Unit for Remote Control Via SNMP
Port
For the unit to be controlled via the SNMP Ethernet port, the control mode
of the IRD needs to be set to Network (SNMP).
Table 4.1: Configuring the Serial Remote Port and Activating Remote Protocol (SNMP)
Step Action Result
1. Go to menu 7.1. Displays ‘OPERATING MODE’.
2. Press Edit. Displays ‘FRONT PANEL’.
3.
Press the down pushbutton and select
‘NETWORK (SNMP)’.
The settings should be set to match the external control host.
4. Press Save. The unit is ready for Remote Control.
NOTE…
The remote control protocols are not contained as a part of the product. An additional licence fee, NDA
or other agreement with TANDBERG may be necessary to obtain the information required to control
the product remotely.
4.1.4 Configuring the Unit For Remote Control Via the
Serial Remote Port
For the unit to be controlled via RS-232 or RS-485, the control mode of
the IRD needs to be set to Serial Remote and serial remote protocol
must be chosen (RS-232 Alteia or RS-485 Alteia).