Filter
Top Products
3M™ MicroTouch™ Software MT 7 User Guide 13
3M Touch Systems, Inc. Proprietary Information – 25695M
CHAPTER 2
MT 7 Software Control Panel
Overview
The MT 7 software control panel consists of tabs that allow you to determine the best
settings for your touch system configuration.
• Use the Main tab to run a 3-point calibration routine for optimum accuracy of your
sensor.
• Use the Touch Settings tab to define the touch actions that equate to mouse actions
and add right-click functionality to the touch sensor.
• Use the Edge Adjustment tab to define a frame around the active touch area in which
the cursor moves closer to the edges of the sensor.
• Use the Tools tab to restore hardware or software defaults, reset controller, run Draw
Test from the desktop, and to enable Advanced Options for your touch sensor.
• Use the Controller tab to activate linearization, select frequency, set controller ID,
and determine pen/finger modes. Note that this tab appears only if you have selected
the appropriate options from the Advanced Options from the Tools tab and have the
specific type of controller attached to your system.
Opening the MT 7 Control Panel
You can open the MT 7 control panel by clicking:
Start → Programs → MicroTouch MT 7 → Control Panel.
Note: In Linux, use StartCP to launch the control panel