Filter
Top Products
3M™ MicroTouch™ Software MT 7 User Guide 25
3M Touch Systems, Inc. Proprietary Information – 25695M
If after restoring controller factory defaults, you lose touch, you will need to reboot in
order to restore touch.
Note: You must perform a calibration after restoring controller defaults.
Reset Controller
Use this only at the direction of Technical Support. This command initializes the
hardware and the firmware, causes the controller to stop sending data, and recalculates
the environmental conditions (for example, stray and offset values). The Reset command
also cancels existing commands and returns the controller to normal operation.
Advanced Touch Options
Important Note: Executing the Advanced Options may alter the performance of your
sensor or render it inoperable. You should be aware of expected results before executing
any option. If you are not familiar with the outcome of these settings, you should not be
using these options.
This option controls certain advanced functions for your controller. Depending on the
options you have selected and the availability of that function for your given controller,
you can choose certain Advanced Options from this screen.
• Enable manual linearization (only for EX and some RX series controllers)
• Enable pen/finger selection (only for SX controllers)
• Enable frequency selection (only for EX capacitive controllers)
• Enable controller identifier editing (helpful in multiple display setups)
Refer to the Controller Tab for a discussion of the various options associated with these
Advanced Options settings.