Filter
Top Products
18-EN
Searching Directly by Chapter or Track Number
Use this function to easily move to the beginning of the chapters or
tracks on the disc.
• This operation is performed by the remote control unit.
1
During playback or pre-stop, input the chapter or
track number you desire using the number keys
(“0” to “9”).
2
Press ENT.
Playback starts from the selected chapter or track.
• This function cannot be used on discs on which no chapter
numbers are recorded.
• The beginning of a track number cannot be directly found on the
Video CD equipped with PBC (playback control). Set VCD PLAY
MODE to turn the PBC function off. Refer to “Setting the Video
CD Play Mode” (page 35).
• Depending on the number of digits input, playback may start
automatically even if ENT. is not pressed in step 2.
• Press CLR to delete the last digit in the chapter/track number.
Press and hold CLR for at least 2 seconds to clear “Chapter” and
“Track” numbers.
• Press RETURN to cancel the chapter/track search mode and
resume normal playback.
Chapter/Track/Title Repeat Playback
Use this function to play the disc’s titles, chapters or tracks repeatedly.
1
Press FUNC. to activate the audio function mode.
Source select mode → Audio function mode 1* →
Audio function mode 2 → Source operation mode →
Source select mode
* DVD mode only.
2
Press the GlideTouch bar under RPT to select the
RPT mode.
The repeat mode switches each time the button is pressed.
DVD
• By pressing GlideTouch bar under RPT for more than 2 seconds,
the unit will switch to REPEAT OFF.
VIDEO CD
The track is played repeatedly.
The entire disc is played repeatedly.
(Factory default)
Playback does not repeat.
The chapter is played repeatedly.
The title is played repeatedly.
The mode returns to normal
playback. (Factory default)
↓
RPT CHAPT
↓
RPT TITLE
↓
RPT OFF
↓
RPT TRACK
↓
RPT DISC
↓
RPT OFF
*
Switching the Audio Tracks
DVDs can have up to 8 different audio tracks. These alternate tracks
can be switched during playback.
• This operation is performed by the remote control unit.
During playback, press AUDIO.
The sound switches between the alternate audio tracks
recorded on the disc each time the button is pressed.
• The selected audio track becomes the default setting every time the
power is turned on or the disc is replaced. If a disc does not
include the language you selected for the default audio track, the
disc’s default language is selected instead. Refer to “Setting the
language” (page 32).
• Not all discs will allow changing the alternate audio tracks during
playback. In these cases, select audio tracks from the DVDs menu.
• There may be a delay before the selected alternate track begins to
play.
Video CDs with multiplex audio
During playback, press AUDIO.
The left and right channels will be output as shown in the figure
below, each time the button is pressed.
LR → LL → RR → LR
Switching the Angle (DVD only)
On DVDs in which scenes have been filmed from multiple angles, the
angle can be switched during playback.
• This operation is performed by the remote control unit.
During playback, press ANGLE.
The angle switches between the angles recorded on the disc
each time the button is pressed.
• Some time may be required for the angle to change.
• Depending on the disc, the angle may switch in one of two ways.
- Seamless: The angle switches smoothly.
- Non-seamless: When the angle is switched, a still picture is
displayed first, after which the angle switches.
* Displayed only in the changer mode.
• The track/disc repeat modes cannot be used on video CDs with
playback control (PBC). Set VCD PLAY MODE to turn the PBC
function off. Refer to “Setting the Video CD Play Mode” (page 35).
• For some discs it is not possible to switch the repeat mode.