Filter
Top Products
20-EN
;/:/8/9/
ENT.
RTN
GlideTouch bar Operation
The GlideTouch bar controls the same functions as the unit buttons
and remote control.
1
Press FUNC. then select the desired mode.
Source select mode →
Audio function mode 1* (;, :, ENT., etc.) →
Audio function mode 2 (AUDIO, RPT, etc.) →
Source operation mode (g, f , etc.) →
Source select mode
* DVD mode only.
2
The function guide of the selected mode is
displayed.
3
Press the position on the GlideTouch bar which
corresponds to the function guide in the display.
Source Operation Mode
<DVD/Video CD mode>
L Stopping Playback (PRE-STOP) pgae17
L Stopping Playback page17
(/) Fast-forward/Fast-reverse page17
g/f Find the Beginning of Chapters or Tracks page17
: Playback page17
J Still (pause) page17
g/f Forward/Reverse frame-by-frame playback page17
(/) Slow Motion Playback page17
Audio Function Mode
<DVD mode>
page16
Return to the previous display
(Depending on the disc, it may not be possible to
return to the previous display.)
FUNC. Press FUNC. to change.
TOP.M Recall the top menu display page16
MENU Recall the menu display page16
AUDIO Switching the Audio Tracks page18
SUBT. Switching the Subtitles page19
ANGLE Change the angle page18
RPT Chapter/Title repeat playback page18
<Video CD mode>
AUDIO Change audio output page18
RPT Chapter/Track repeat playback page18
PBC Set Video CD playback mode page35
RTN Return to the previous display
(Depending on the disc, it may not be possible to
return to the previous display.)
Sound Setting
Adjusting Balance (Between Left and Right)/
Fader (Between Front and Rear)/Defeat
1
Press the Rotary encoder (MODE) repeatedly to
choose the desired mode.
Each press changes the mode as follows:
SUBWOOFER*
1
→ BALANCE → FADER → DEFEAT →
VOLUME → SUBWOOFER*
1
Subwoofer : 0 ~ +15
Balance : L15 ~ R15
Fader : R15 ~ F15
Defeat : ON/OFF
Volume : 0 ~ 35
Press g or f after selecting the Subwoofer mode,
and the subwoofer output phase is switched NORMAL
(PHASE 0°) or REVERS (PHASE 180°).
• If the Rotary encoder (MODE) is not pressed within 5 seconds
after selecting the BALANCE, FADER, DEFEAT or SUBWOOFER
mode, the unit automatically returns to normal mode.
• If you set the 2WAY/3WAY switch (pages 68, 69 and 71) to 3WAY,
you cannot adjust the FADER mode.
*
1
When the subwoofer mode is set to OFF, its level and phase cannot
be adjusted.
2
Turn the Rotary encoder (MODE) until the
desired sound is obtained in each mode.
By setting Defeat ON, previously adjusted settings of EQ
will return to the factory defaults and MX is turned off.
• If an external audio processor is connected, refer to “External
Audio Processor (Optional)” (pages 45 to 53)
BAND
SOURCE/
POWER
g
f
FUNC. GlideTouch bar
Rotary encoder (MODE)
MENU
B
C
Selection button when the menu display is
indicated.