Filter
Top Products
Upgrading MVP Firmware
39
MVP-7500/8400 Modero Viewpoint Wireless Touch Panels
Upgrading MVP Firmware
Except for the MVP-KS (Kickstand for MVP Panels), all MVP panels and their accessories have on-board firmware
which is upgradeable through the use of the latest NetLinx Studio. The MVP acts as a bridge between the NetLinx
Studio program and the installed docking station. Studio can download firmware to the target docking station by using
the connected MVP to pass-along the Kit file to the docking station. Refer to the NetLinx Studio version 2.x or higher
Instruction Manual for more information on how to download firmware to both a panel and a docking station.
1. Upload the latest Kit file (SW5965_xx version 2.70.xx or higher) to your specific Modero touch panel and then
confirm the firmware file update was successful. Refer to your panel’s instruction manual for detailed
communication and Kit file upload procedures.
Before beginning the Upgrade process:
Setup and configure your NetLinx Master. Refer to the your particular NetLinx Master Instruction Manual for
detailed setup procedures.
Calibrate and prepare the communication pages on the Modero panel for use. Refer to the Panel
Calibration section on page 155.
Refer to the NetLinx Studio version 2.x or higher Help file for more information on uploading files via
Ethernet.
Configure your panel for either direct connect or wireless communication. Refer to the Configuring
Communications section on page 19 for more detailed information about Ethernet or Wireless
communication.
The process of updating firmware involves the use of a communicating NetLinx Master. The required steps for updating
firmware to a Modero panel are virtually identical to those necessary for updating Kit files to a NetLinx Master (except
the target device is a panel instead of a Master). Refer to either your Master’s literature or Studio 2.x Help file for those
procedures.
The latest firmware 2.70.xx (or higher) kit file is panel-specific.
This new firmware also provides both backwards compatibility with the previous
802.11b cards and new security protocols for the new 802.11g wireless CF card.
If you don’t first update the firmware file on the panel, before proceeding with the card
upgrade process, you will be required to configure NetLinx Studio to communicate
with the target panel via a direct USB connection.
In this communication scenario, your PC acts as a Virtual NetLinx Master establishing
a secure USB connection to the target panel and then uploading the new Kit file.
It is recommended that firmware Kit files only be transferred over a direct connection
and only when the panel is connected to a power supply.
If battery power or wireless connection fails during a firmware upgrade, the panel
flash file system may become corrupted.
A touch panel which is not using a valid username and password will not be able to
communicate with a secured Master. If you are updating the firmware on or through a
panel which is not using a username or password field, you must first remove the
Master Security feature to establish an unsecured connection.