Filter
Top Products
CHAPTER 2: IP CONFIGURATION
6 Click
the “
Save Settings”
button to store the configuration changes to the
HS500E’s non-volatile flash memory.
7
Manually
cycle power
to the HS500E. It takes 15 – 30 seconds for the
HS500E to reboot, at which time your IP configuration changes will be
implemented.
8
After the HS500E has completely restarted,
verify
the new IP configuration
by opening a Web browser and entering the newly assigned IP address in
the URL field.
2.3 PINGING THE HS500E
After the HS500E has restarted, go to the PC and run PING.EXE (from Microsoft
Windows systems) or use another network diagnostic tool that can run a similar
TCP/IP ping command. Using a Ping utility helps verify that the HS500E is accessible
across the network.
•
To Ping the HS500E from the PC, open a command prompt and at the C:\>
prompt type:
Ping (IP Address)
(Where “IP Address” is the new IP address assigned to the HS500E).
If the HS500E is online and functioning, a successful response will be similar to:
Reply from (IP Address): bytes=32 time=3ms TTL=60
Reply from (IP Address): bytes=32 time=1ms TTL=60
Reply from (IP Address): bytes=32 time=1ms TTL=60
Reply from (IP Address): bytes=32 time=1ms TTL=60
If the PC does not receive a successful response from the HS500E, it may indicate
an improperly configured IP address setting. Please verify that you followed the
instructions above for setting the IP address of the HS500E.
Also, be sure to disable any firewall services running on the PC. Firewalls can
potentially block communications between the PC, the PLC and/or the HS500E.
HS500E – OPERATOR’S MANUAL P/N: 17-1305 REV02 (12-05)
PAGE 20 OF 82