Filter
Top Products
TIMER
DISPLAY
SLEEP
MODE
FLAT TONE
ENTER
TUNING
RANDOM REPEAT P.MODE
AUTO / MONO
ClearA
VOL
RC-R0830E
P.CALL
TUNER D.AUDIO CD
BAND
AUX
PHONO
TAP E
D-IN1 D-IN2 D-IN3
ROOM EQ
MUTE
CLEAR
DIMMER
MODE
SOUND
PRESET
32
R-K1000
Playback from External Components
You can play tracks by connecting external components to the system.
External Components
Connect the external component to the system as described in “Connecting
Other Accessories (Commercially Available Units)” (P.13–15).
When connecting external components, always turn this system and the external
components o beforehand.
Refer also to the instruction manual for the external component to be connected.
z
z
33
Adjust the volume level.
Select the input source to be used for playback.
22
Begin playback on the connected external component.
Begin playback using the controls on the connected external component.
When a digital component is
selected, the input signal sampling
frequency is displayed.
The R-K1000 will play PCM (32 kHz
– 96 kHz) digital signals.
z
Turn the [INPUT SELECTOR] knob to select the input
source to be used for playback.
The input source changes as shown below each time you press the key.
The display changes as shown below each time you press the [DISPLAY] key.
When “D.AUDIO”, “PHONO”, “TAPE” or “AUX” is selected:
Selected input source
Day/Clock
When “CD”, “D-IN1”, “D-IN2” or “D-IN3” is selected:
Selected input source/Sampling frequency
Day/Clock
z
11
FM AM CD PHONO TAPE
D-IN3 D-IN2 D-IN1 D.AUDIO AUX