Filter
Top Products
22 C4658M-C (6/10)
CONNECTING VIDEO INPUT
The NET5400T Series automatically detects the video standard (PAL or NTSC) and accepts both color and black-white
analog video.
To connect video input:
1. Connect a coaxial cable to the camera or other analog video source.
2. Connect the coaxial cable to the video in connector on the rear panel.
3. If not using looping video, you must set the video termination for the camera. Video termination can be set from the
WS5200 advanced system management software.
The unit supports Coaxitron up-the-coax operation to a PTZ device. When the unit receives a camera control command, it
transmits that command up the coaxial cable to the PTZ device. Since Coaxitron is a single-direction protocol, the PTZ
device cannot return any data to the unit. By default, Coaxitron is disabled.
This unit also supports a serial PTZ device that uses the Pelco D protocol, such as the Spectra
®
dome. Connect the coaxial
cable from the device, and then refer to Connecting a PTZ Device (Pelco D) on page 25 to connect the camera control leads.
CONNECTING LOOPING VIDEO
The NET5400T Series supports looping video on the 1- and 2-channel models. It passes the video input to a monitor or
other analog video device.
To use looping video:
1. Connect a coaxial cable to the video out connector on the rear panel of a 1-channel model.
2. Connect the other end of the coaxial cable to the analog device.