Filter
Top Products
Before you start
01
10
En
Checking what’s in the box
Please check that you’ve received the following supplied
accessories:
•Setup microphone (cable: 5 m (16.4 ft.))
• Remote control unit
• AAA size IEC R03 dry cell batteries (to confirm system
operation) x2
•AM loop antenna
•FM wire antenna
• iPod cable
•Power cord
•These operating instructions
Installing the receiver
• When installing this unit, make sure to put it on a
level and stable surface.
Don’t install it on the following places:
– on a color TV (the screen may distort)
– near a cassette deck (or close to a device that gives off
a magnetic field). This may interfere with the sound.
– in direct sunlight
– in damp or wet areas
– in extremely hot or cold areas
– in places where there is vibration or other movement
– in places that are very dusty
– in places that have hot fumes or oils (such as a kitchen)
• Do not touch this receiver’s bottom panel while the
power is on or just after it is turned off. The bottom
panel becomes hot when the power is on (or right
after it is turned off) and could cause burns.
Loading the batteries
The batteries included with the unit are to check initial
operations; they may not last over a long period.
We recommend using alkaline batteries that have a
longer life.
CAUTION
Incorrect use of batteries may result in such hazards as
leakage and bursting. Observe the following precautions:
• Never use new and old batteries together.
•Insert the plus and minus sides of the batteries
properly according to the marks in the battery case.
•Batteries with the same shape may have different
voltages. Do not use different batteries together.
• When disposing of used batteries, please comply
with governmental regulations or environmental
public instruction’s rul
es th
at apply in your country or
area.
• WARNING
Do not use or store batteries in direct sunlight or
other excessively hot place, such as inside a car or
near a heater. This can cause batteries to leak,
overheat, explode or catch fire. It can also reduce the
life or performance of batteries.
Operating range of remote control unit
The remote control may not work properly if:
•There are obstacles between the remote control and
the receiver’s remote sensor.
•Direct sunlight or fluorescent light is shining onto the
remote sensor.
•The receiver is located near a device that is emitting
infrared rays.
•The receiver is operated simultaneously with another
infrared remote control unit.
Tip
• By connecting an RF adapter to the RS-232C and
EXTENSION terminals, the CU-RF100 omni-
directional remote control can be used for RF two-
way communications with the receiver.
1
With RF two-
way communications, the information of the
receiver’s display can be displayed on the remote
control in your hands and the remote control can be
operated without worrying about obstacles or the
direction in which the remote control is pointing.
2
Note
1 The RF adapter and CU-RF100 omni-directional remote control are sold separately.
2 The maximum line-of-sight distance for RF two-way communications is about 10 meters. This line-of-sight communications distance is a rough
indication, and may differ according to the surrounding environment.
7 m (23 ft.)
30°
30°
SC-1525_UXJCB.book 10 ページ ２０１０年４月２０日 火曜日 午後７時３２分