Filter
Top Products
Basic playback
05
44
En
Playing a USB device
It is possible to play files
1
using the USB interface on the
front of this receiver.
1 Switch on the receiver and your TV.
See Connecting a USB device on page 35.
2
2 Press
iPod USB
on the remote control to switch the
receiver to the
iPod/USB
.
3
Loading appears in the GUI screen as this receiver starts
recognizing the USB device connected. When the display
shows the USB Top menu you’re ready to play from the
USB device.
Important
If an Over Current message lights in the display, the
power requirements of the USB device are too high for
this receiver. Try following the points below:
• Switch the receiver off, then on again.
• Reconnect the USB device with the receiver switched
off.
• Use a dedicated AC adapter (supplied with the
device) for USB power.
If this doesn’t remedy the problem, it is likely your USB
device is incompatible.
Playing back audio files stored on a USB
memory device
The maximum number of levels that you can select in
Step 2 (below) is 8. Also, you can display and play back
up to 30 000 folders and files within a USB memory
device.
4
1Use
/
to select ‘Music’ from the
USB Top
menu.
2Use
/
to select a folder, then press
ENTER
to
browse that folder.
•To return to the previous level any time, press
RETURN.
3 Continue browsing until you arrive at what you
want to play, then press
to start playback.
5
Basic playback controls
This receiver’s remote control buttons can be used for
basic playback of files stored on USB memory devices.
•Press iPod USB to switch the remote control to the
iPod/USB operation mode.
Playing back photo files stored on a USB
memory device
6
1Use
/
to select ‘
Photo
s’ from the
USB Top
menu.
2Use
/
to select a folder, then press
ENTER
to
browse that folder.
• To return to the previous level any time, press RETURN.
3 Continue browsing until you arrive at what you
want to play, then press
to start playback.
7
The selected content is displayed in full screen and a
slideshow starts.
After a slideshow launches, pressing ENTER toggles
between play and pause (only when Theme on the
Slideshow Setup is set to Normal (OFF)).
Basic playback controls
Note
1• Compatible USB devices include external magnetic hard drives, portable flash memory drives (particularly key drives) and digital audio
players (MP3 players) of format FAT16/32.
• Pioneer cannot guarantee compatibility (operation and/or bus power) with all USB mass storage devices and assumes no responsibility for
any loss of data that may occur when connected to this receiver.
2Make sure the receiver is in standby when disconnecting the USB device.
3 The iPod/USB function cannot be selected in the main zone when the Internet radio function is selected in the sub zone. Also, the iPod/USB
function cannot be selected in the sub zone when the Internet radio function is selected in the main zone.
4 Note that non-Roman characters in the playlist are displayed as #.
5• Copyrighted audio files cannot be played back on this receiver.
• DRM-protected audio files cannot be played back on this receiver.
6 Photo files cannot be played in the sub zone.
7 If the slideshow is left in the pause mode for five minutes, the list screen reappears.
Button(s) What it does
ENTER, Starts displaying a photo and playing a slideshow.
RETURN,
Stops the player and returns to the previous
menu.
a
a.You can only use this button when Theme on the Slideshow Setup
is set to Normal (OFF)
Displays the previous photo content.
a
Displays the next photo content.
a
Pauses/unpauses the slideshow.
DISP
a
Displays the photo information.
iPod CTRL
HOME
MENU
TUNE
TUNE
TOOLS
LIST
PRESET
TOP MENU
BAND GUIDE
T.EDIT
VIDEO
PARAMETER
AUDIO
PARAMETER
ENTER
PRESET
RETURN
CATEGORY
SIGNAL SEL
MCACC SLEEP
HDMI OUT
TV
/
DTV MPX PQLS
PHASE
CTRL STATUSTHX
STEREO
DIRECT
STANDARD
ADV SURR
AUDIO
INFO
DISP
HDD DVD
546
213
SC-1525_UXJCB.book 44 ページ ２０１０年４月２０日 火曜日 午後７時３２分