Filter
Top Products
19
En
SET UP
1 Press .
2 Press VOL + or – to adjust the volume to an appropriate
level.
3 Press TEST TONE to output the test tone.
The test tone is output in the following order.
• Depending on the “SPEAKER setting mode” chosen, some
channels may not output test tone (refer to page 15).
• Test tone is only output in Dolby Surround mode.
4 Adjust speaker levels so that you hear the test tone at
the same volume from each speaker when seated in the
main listening position.
The channel level ranges +10dB~ –10dB.
• Levels can be set for each surround mode.
• When both the DSP mode and Dolby Surroud mode are turned
on, priority is given to the Dolby Surround mode.
5 Press TEST TONE to turn off the test tone.
• Sound from the SUB WOOFER seems quiet.
• The speaker volume can be adjusted without outputting the test tone by pressing CHANNEL LEVEL or
CHANNEL SELECT .
• Initial setting is 0 dB.
FL
CT FR
SR
SL
SW
Setting the volume level of each channel (Adjusting the speaker volume balance)
Preparations
DVD/LD
VCR 1
TV/SAT
CD
TUNER
VCR 2
MD/TAPE
TV CONTROL
AMP
DSP MODE
CH.SELECT
ATT SIG.SELECT
MIDNIGHT
TEST TONE
AUDIO/VIDEO PRE-PROGRAMMED
REMOTE CONTROL UNIT
2
3
5
0
6
9
+10
TV/VCRCLASS
7
8
4
1
CHANNEL
MULTI CONTROL
ENTER
VOL VOL
FQ
FQ
+
–
TV FUNC
AMP
TV
MUTING
CH.LEVEL
EFFECT
FL DIMMER FUNCTION DIRECT
MODE CHECK
COMMANDER
SET UP
Î
MEMU
1
2
3,5
4
memo
memo
memo