Filter
Top Products
30
En
1 Press AMP.
This sets the remote to select the sound mode.
(You can skip this step when using the controls on the amplifier.)
2 Press DSP MODE to select the sound mode.
Each press changes the DSP mode as follows:
Selecting a Sound Mode
To ensure the best possible surround sound, be sure to complete the set up procedures described in “Setting Up for
Surround Sound” (starting on page 14) before using the sound modes. This is particularly important when using the
(Dolby) Surround mode. When using the sound modes, SPEAKERS A are used. If SPEAKERS B are selected and a
sound mode is turned on, selection automatically switches to SPEAKERS A only.
Surrround operation
Sound Modes
=HALL 1 = HALL 2 = JAZZ = DANCE
SFC OFF+ THEATER 2 + THEATER 1 +
• The amount of effect of each DSP mode can be adjusted in the range of 10
to 90 (the default setting value is 70) by pressing EFFECT –/+.
1
2
DVD/LD
VCR 1
TV/SAT
CD
TUNER
VCR 2
MD/TAPE
TV CONTROL
AMP
DSP MODE
CH.SELECT
ATT SIG.SELECT
MIDNIGHT
TEST TONE
AUDIO/VIDEO PRE-PROGRAMMED
REMOTE CONTROL UNIT
2
3
5
0
6
9
+10
TV/VCRCLASS
7
8
4
1
CHANNEL
MULTI CONTROL
ENTER
VOL VOL
FQ
FQ
+
–
TV FUNC
AMP
TV
MUTING
CH.LEVEL
EFFECT
FL DIMMER FUNCTION DIRECT
MODE CHECK
COMMANDER
SET UP
Î
MEMU
EFFECT –/+
memo
2