Filter
Top Products
33
En
OPERATION
Recording from Audio Components
The following operations show you how to record audio to the cassette, DAT, or MD deck connected to the MD/TAPE
jacks.
1 Prepare the program source.
(Tune in the radio station or load the CD, etc.)
2 Select the component you want to record.
Press SIG. SELECT on the remote or SIGNAL SELECT on the front
panel to select “ANALOG” when making analog recordings, or
“DIGITAL” when making digital recordings. (Refer to “Switching
ANALOG/DIGITAL signal input” on page 27.)
3 Insert a blank tape into the cassette deck (MD/TAPE) and
adjust the recording level (if necessary).
4 Start recording on the cassette deck, then start playback
from the source component.
Other Operations
2
SIGNAL SELECT
DVD/LD
VCR 1
TV/SAT
CD
TUNER
VCR 2
MD/TAPE
TV CONTROL
AMP
DSP MODE
CH.SELECT
ATT SIG.SELECT
MIDNIGHT
TEST TONE
AUDIO/VIDEO PRE-PROGRAMMED
REMOTE CONTROL UNIT
2
3
5
0
6
9
+10
TV/VCRCLASS
7
8
4
1
CHANNEL
MULTI CONTROL
ENTER
VOL VOL
FQ
FQ
+
–
TV FUNC
AMP
TV
MUTING
CH.LEVEL
EFFECT
FL DIMMER FUNCTION DIRECT
MODE CHECK
COMMANDER
SET UP
Î
MEMU
SIG. SELECT
The amplifier’s volume, tone (BASS, TREBLE, MIDNIGHT and LOUDNESS), and surround effects have no
effect on the recorded signal.
memo
2
• This amplifier outputs the input signal directly to the recording
device. As there is no conversion of the audio signal,
recordings cannot be made from analog to digital, and similarly
from digital to analog.
• Recording cannot be made from MD/TAPE.
memo