Filter
Top Products
34
En
Other Operations
Recording from Video Components
The following operations show you how to record audio and video to the video tape recorder connected to the VCR
jacks.
1 Prepare the program source.
(Load the DVD or LD, etc.)
2 Select the component you want to record.
Be sure to press SIG. SELECT on the remote or SIGNAL SELECT on the
front panel to choose “ANALOG”. (Refer to “Switching ANALOG/
DIGITAL signal input” on page 27.)
3 Insert a blank tape into the video tape recorder VCR.
4 Start recording on the video tape recorder, then start
playback from the source component.
2
DVD/LD
VCR 1
TV/SAT
CD
TUNER
VCR 2
MD/TAPE
TV CONTROL
AMP
DSP MODE
CH.SELECT
ATT SIG.SELECT
MIDNIGHT
TEST TONE
AUDIO/VIDEO PRE-PROGRAMMED
REMOTE CONTROL UNIT
2
3
5
0
6
9
+10
TV/VCRCLASS
7
8
4
1
CHANNEL
MULTI CONTROL
ENTER
VOL VOL
FQ
FQ
+
–
TV FUNC
AMP
TV
MUTING
CH.LEVEL
EFFECT
FL DIMMER FUNCTION DIRECT
MODE CHECK
COMMANDER
SET UP
Î
MEMU
SIG. SELECT
SIGNAL SELECT
The amplifier’s volume, tone (BASS, TREBLE, MIDNIGHT and LOUDNESS), and surround effects have no
effect on the recorded signal.
• Recording cannot be made from analog to digital, and similarly
from digital to analog.
• When recording a DVD, the recorded image may flicker or be
difficult to view because of the copy protection signal
programmed on the DVD.
memo
memo
2