Filter
Top Products
27
En
OPERATION
Switching ANALOG/DIGITAL Signal Input
The input of the component set in the digital input setting (Refer to page 18) can be switched to an analog or digital
input signal by pressing the SIGNAL SELECT button.
2 Press SIG. SELECT on the remote control or SIGNAL
SELECT on the front panel to select the input signal
corresponding to the source component.
Each press switches between ANALOG and DIGITAL signal selection.
3
DVD/LD
VCR 1
TV/SAT
CD
TUNER
VCR 2
MD/TAPE
TV CONTROL
AMP
DSP MODE
CH.SELECT
ATT SIG.SELECT
MIDNIGHT
TEST TONE
AUDIO/VIDEO PRE-PROGRAMMED
REMOTE CONTROL UNIT
2
3
5
0
6
9
+10
TV/VCRCLASS
7
8
4
1
CHANNEL
MULTI CONTROL
ENTER
VOL VOL
FQ
FQ
+
–
TV FUNC
AMP
TV
MUTING
CH.LEVEL
EFFECT
FL DIMMER FUNCTION DIRECT
MODE CHECK
COMMANDER
SET UP
Î
MEMU
• SIGNAL SELECT is fixed in the “ANALOG” position for components not
assigned to one of the three digital input jacks.
• Because the audio from a karaoke microphone and LD recorded with
analog audio only is not output from the digital output, set SIGNAL
SELECT to “ANALOG”.
• This amplifier can only playback Dolby Digital, PCM (32kHz, 44kHz, and
48kHz) signal formats. With digital signal formats other than these, set
SIGNAL SELECT to “ANALOG”.
Sound Modes
SP
SIGNAL
SELECT
ANALOG
SIGNAL
SELECT
ANALOG
A
SP
SIGNAL
SELECT
DIGITAL
SIGNAL
SELECT
DIGITAL
A
While SIGNAL SELECT is set to DIGITAL, AC-3 lights when a Dolby
Digital signal is input.
When a Dolby Digital signal is input.
SP
SIGNAL
SELECT
DIGITAL
AC-3
SIGNAL
SELECT
DIGITAL
AC-3
A
memo
1 Press AMP.
This sets the remote to select the sound mode.
(You can skip this step when using the controls on the amplifier.)
1
2
2