Filter
Top Products
20
En
1 Press COMMANDER SET UP and 1 at the same time to
select the preset mode.
The MULTI CONTROL buttons on the remote control start to blink.
To cancel the preset mode
Press COMMANDER SET UP.
2 Press the MULTI CONTROL button for the component you
want to control.
Each button can be set to control one of the following components
DVD/LD
: DVD/LD player
TV/SAT
: TV or Satellite tuner
CD
: CD player
: Tuner
MD/TAPE
: MD recorder or Tape recorder
VCR 1
: Video deck
VCR 2
: Video deck
: TV or Cable TV tuner
3 Point the remote control toward the component to be
controlled, enter the 3 digit setup code.
When a three digit code number is input, a power ON/OFF signal is
output from the remote control unit. If the power of the device turns
ON or OFF corresponding to this signal, it indicates that the device has
been set properly. If the power does not turn ON/OFF, input another
code.
Repeat steps 2 through 3 to assign preset codes for as many
components as necessary.
Preparations
Setting Up the Remote Control
In addition to controlling the amplifier, the supplied remote control can operate your other components (DVD, MD, VCR,
TV, LD, CD, etc.). If your component(s) are listed in the “Preset Code List” on page 44, simply recall the corresponding
preset code. This remote control is factory set with the codes used to operate PIONEER components.
If you want to change the preset codes to operate components made by other manufacturers, follow the procedure
outlined below.
Recalling preset codes
The following steps show you how to recall preset codes for each MULTI CONTROL button. Once the preset code is
assigned, pressing the button will automatically set the remote to operate the respective component.
• Refer to “Preset Code List” on page 44 for the components and manufacturers available.
• Refer to “Remote Controlling Other Components” on pages 35 to 40 and “Background Control of Other
Components” on page 41 for detailed explanations on how to operate your other components.
DVD/LD
VCR 1
TV/SAT
CD
TUNER
VCR 2
MD/TAPE
TV CONTROL
AMP
DSP MODE
CH.SELECT
ATT SIG.SELECT
MIDNIGHT
TEST TONE
AUDIO/VIDEO PRE-PROGRAMMED
REMOTE CONTROL UNIT
2
3
5
0
6
9
+10
TV/VCRCLASS
7
8
4
1
CHANNEL
MULTI CONTROL
ENTER
VOL VOL
FQ
FQ
+
–
TV FUNC
AMP
TV
MUTING
CH.LEVEL
EFFECT
FL DIMMER FUNCTION DIRECT
MODE CHECK
COMMANDER
SET UP
Î
MEMU
1
2
3
memo
TUNER
TV CONTROL