Safety Summary
viii
Teklogix 8570 Vehicle-Mount Computer User Manual
This device complies with Part 15 of the FCC Rules. Operation is subject to the fol-
lowing two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interfer-
ence that may cause undesired operation.
RF E
XPOSURE
R
EQUIREMENTS
To satisfy FCC RF exposure requirements for mobile transmitting devices,
a separation distance of 20 cm or more should be maintained between the
antenna of this device and persons during device operation. To ensure com-
pliance, operation at closer than this distance is not recommended.
F
OR
USE
IN
C
ANADA
(2412 - 2462 MH
Z
)
This device requires a radio licence, unless it is installed totally within a
building. (User shall obtain this licence from Industry Canada).
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio fre-
quency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communication. However, there is no guar-
antee that interference will not occur in a particular installation.
Important:
The 500 MHz 8570 Vehicle-Mount Computer is not for home or
office use.
If this equipment does cause interference to radio or television reception, which can
be determined by turning the equipment on and off, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.