Filter
Top Products
Teklogix 8570 Vehicle-Mount Computer User Manual 29
Chapter 3: Operating Information
Ports
3.5 Ports
There are eight connectors on the back of the 8570, which can be used for the
addition of a variety of peripheral accessories. These connectors are protected from
harsh environments by an IP66 cable cover and gasket. The connector locations and
gasket arrangement are shown in Figure 3.5 on page 31.
In addition, there are two PCMCIA slots on the top of the computer that are
available for PC card devices.
Specific accessories are described in section 3.7 on page 36.
Important: If peripherals are connected to the 8570, the IP66 cover must be
removed. The cables for the peripheral(s) are then placed through
the blue gasket. For detailed instructions, refer to “Connecting
Cables”, below.
3.5.1 Connecting Cables
There are several steps to take to properly seal the computer around the attached
cables. Before following these instructions, refer to Figure 3.5 on page 31 for a
diagram of the cable gasket, cover and screws.
1. Remove the sealing plate screws (five TORX 10 [T10] screws
and washers).
2. Carefully remove the plate and bottom half of the cable gasket.
Important: Do not misplace the black sealing plugs since you may need them
for future use.
3. Ensure that each required cable position is correctly identified. Remove
the peelable sections of the cable gasket until the correct cable diameter
is obtained, and retain the sections for future use.
4. Install each required cable into its correct connector on the computer,
and run the cable through the prepared gasket slot. Leave 1-2 cm of
slack under the cover.
5. Carefully replace the cable gasket, ensuring proper alignment of the
cables that are passed through.
6. Re-install the cover by aligning the slots at the back and securing the five
screws and washers.