Filter
Top Products
Chapter 2: Getting Started
Connecting Accessories
22
Teklogix 8570 Vehicle-Mount Computer User Manual
Important: If peripherals are connected to the 8570, the IP66 cover must be
removed. The cables for the peripheral(s) are then placed through
the blue cable gasket. For detailed instructions, refer to “Connect-
ing Cables” on page 29.
3. Connect the power cable to the power source, and to the power connec-
tor (for detailed instructions, see “Power Options” on page 60).
4. Turn on your 8570 by pressing the power button.
Note: When the 500 MHz 8570 Vehicle-Mount Computer is first supplied with
power, the unit will power up automatically. Subsequent operation is the
same as the standard 8570. If the 500 MHz unit is disconnected and then
reconnected to a power source, it will again power up automatically.
5. When the start-up sequence is complete, you may run your applications.
Powering Down
1. Close all applications.
2. Choose “Shut Down” from the Start menu.
3. Alternatively, if you need to reset the computer hardware, hold in the
power button until the system shuts down.
2.5 Connecting Accessories
For the location of the different connectors and card slots, please refer to Figure 2.1
on page 18. For instructions on installation and options, refer to “Accessories” on
page 36.