Psion Teklogix 8570 Car Video System User Manual


 
Chapter 2: Getting Started
Precautions
20
Teklogix 8570 Vehicle-Mount Computer User Manual
2.2.3.6 Multimedia Port
The multimedia port is SoundBlaster 16-compatible. If you purchased multimedia
cable PN 31618 with the 8570, connect it to the SoundBlaster-compatible
multimedia port (see Figure 2.1 on page 18). The multimedia cable has a Dsub9
connector and three stereo audio connections: Line In, Line Out, and Mic (input).
Connect your speakers to the correct port on the end of the cable. The speakers must
be amplified.
2.2.3.7 USB Ports
The two USB ports are used to connect any type of USB-compatible device. Each
port has a total 1.1 Amp output.
Warning: The USB and ethernet ports are not to be used for typical end user
applications and installations. These ports are designed to be used
for maintenance and setup purposes only. They should only be used
for temporary service connections required for file transfers, set up,
configuration, etc.
2.2.3.8 Mounting Holes
The mounting holes are used to install the 8570 where needed. For installation
instructions, please refer to Chapter 4: Installation.
2.3 Precautions
2.3.1 Important Safeguards
To avoid possible injury, this device must be properly secured when in a
moving vehicle.
Keep this device away from magnetic fields.
Do not place the computer near a television or radio receiver.
For operating the 8570 in freezer and outdoor environments, it is critical
that the information on page 35 is reviewed and that the guidelines are
strictly followed.
Do not disassemble your 8570 computer—there are no user-serviceable
parts inside.